Steps To Install The Dock Gorilla
-
Quick Check!!
The Dock Gorilla should be secured to your furniture a maximum of 10" above the dock or deck surface.
-
Wrap the Dock Gorilla around identified area and then insert the smaller looped end through the larger looped end and pull tight around your furniture. That’s it!
Steps To Secure To Your Dock Or Deck
-
Quick Check!
For the Dock Gorilla to work, the gap between your deck boards must be a min ⅛” to max ½” apart.
-
Step 1
In the area of your dock or deck where you wish to secure your furniture or water toy, insert the small looped end of the Dock Gorilla through the gap in the deck boards.
-
Step 2
Then slide the locking mechanism down the wire rope and through the deck boards. NOTE: For tight fits, use the wire rope to help work the locking mechanism down through the deck boards.
-
Step 3
Once through, pull up on the wire rope to secure the Dock Gorilla. That’s it!
Steps To Unsecure From Your Dock Or Deck
-
Step 1
Relieve any tension that may be on the wire rope by moving the furniture or water toy as close to the area where the Dock Gorilla is secured to the dock or deck.
-
Step 2
With one hand holding the wire rope, use the other hand to pull up slowly on the colored cord. Pulling in the direction along the wire rope. DO NOT PULL HARD! Use a side to side motion along the gap to work the locking mechanism up in between the deck boards.
-
Step 3
Once the locking mechanism is pulled through the deck boards, pull straight up on the wire rope to fully remove the Dock Gorilla from your dock or deck. That’s it!
